1. In the preparation of the esters given in this experiment, the reaction
product was extracted with 5% sodium bicarbonate solution (NaHCO3) in
the isolation step. Why? What gaswas evolved during this washing step?
Write a balanced equation for the reaction that produced it.
2. Why is a large excess of acetic acidused in the preparation of isopentyl
3. Concentrated sulfuric acid is used as a catalyst for the esterification of
acetic acid in the preparation of isopentyl acetate. Why is sulfuric acid
needed if another acid, acetic acid, is already present?
4. Fatty acids are long-chain carboxylic acids, usually of 12 or more carbon
atoms, isolated from saponification of fatsand oils (esters of glycerol).
Draw the structureof the two fatty acids named below and also determine
their common name.
5. Gas chromatographic analysis of a mixture of organic compoundsgave
the following peak areas (sq cm): hexane = 2.7; heptane = 1.6; hexanol =
1.8; toluene = 0.5.
a. Calculate the molepercent composition of the
mixture. Assume that the response of the detector (area per
mole) is the same for each component.
b. Calculate the weight percent composition of the
mixture, using the same assumptions as in part a.
6. When tert-pentyl bromide is treated with 80% ethanol, the amounts of
alkene productsindicated in your lab textbook on pg. 218 (#6.57) are
detected on analysis. Explain why Compound I is formed in far greater
amount than the terminal alkene.
7. Why is sulfuric acid, rather than hydrochloric acid, used to catalyze the
dehydration of alcohols?
8. A sample of 150 mg of an organic compound is dissolved in 7.5 mL of
water. The solution is placed in a 20-cm polarimeter tube and the rotation
measured in a polarimeter. The rotation observed was +2.676 degrees.
Distilled water, in the same tube, gave a reading of +0.016 degrees.
Calculate the specific rotation for the compound.
9. Compound A is optically active and has the molecular formula C5H10O. On
catalytic hydrogenation (addition of hydrogen) of A, Compound B is
obtained. Compound B has the molecular formula C5H12O and is optically
inactive. Give the structure for Compounds A and B.
10. Which of the following compounds have a meso form?
11. Compounds such as naphthalene and 1,4-dichlorobenzene find use as
mothballs since they sublime at a slow rate at atmospheric pressure.
Explain this behavior in terms of the structure of the molecules.
12. a. How many peaks would you expect to find in the NMR spectrumof
b. What characteristic absorption bands would you expect to find in
the infrared spectrum of caffeine?
13. The vapor pressures of 1,2-diphenylethane, p-dichlorobenzene, and 1,3,5-
trichlorobenzene are 0.06, 11.2, and 1.4 torr, respectively, at their melting
point (52-54 degrees C). Which compound is likely to be sublimed most
rapidly at a reduced pressure of 15 torr and a temperatureof 40 degrees
14. To color spots on TLC plates for easier visualization after elution with
solvent, the plates can be “developed” in a sealed chamber containing
solid iodine. Explain how the solid-vapor equilibriumoperates in this
15. Caffeine is soluble in ethyl acetate. Do you think that the purity of your
product could be checked by TLC using ethyl acetate as an elution
16. List several advantages and disadvantages of steam distillation as a
method of purification.
17. Explain why the distillate collected from the steam distillation of cinnamon
18. Calculate the weight of water required to steam distill 500 mg of
bromobenzene at 95 degrees C. The vapor pressureof water at this
temperature is 640 torr; bromobenzene, 120 torr.
19. Steam distillation may be used to separate a mixture of p-nitrophenoln and
o-nitrophenol. The ortho isomer distills at 93 degrees C; the para isomer
does not. Explain.
20. The chiral carboxylic acid A (C5H6O2) reacts with 1 mol of hydrogen gas
on catalytic hydrogenation. The product is an achiral carboxylic acid B
(C5H8O2). What are the structuresof Compounds A and B?
21. What chemical test would you use to distinguish between the 1-octene
starting material and the octane product?
22. Give the structure and names of five alkenes having the molecular formula
C6H12 that produce hexane on catalytic hydrogenation.
23. In an unsymmetrical alkene, the boron atomadds predominantly to the
least substituted carbonatom. For example, 2-methyl-2-butene gives the
products indicated in your lab textbook on pg. 259 (#6-90). Explain the
24. The decompositionof 3-sulfolene to form 1,3-butadiene generates 1 mole
of sulfur dioxide gas per mole of 1,3-butadiene. Substantial quantities of
SO2 would be generated if this decomposition were carried out on a large
scale. Suggest a method for trapping the gas to prevent its escape into the
25. Two structural isomers are formed when 2-methyl-1,3-butadiene reacts
with ethyl acrylate (ethyl 2-propenoate). Draw structures for these
25 Organic Lab Questions are answered with detailed explanations.